Scope
This Part of this European Standard specifies procedures for quality control and evaluation of conformity,
including marking and labelling of products and systems for the protection and repair of concrete according to
EN 1504, Parts 2 to 7.
2 Normative references
The following referenced documents arensable for the application of this document. For dated
references,only the edition cited applies.For undated references,the latest edition of the referenced
document (including any amendments) applies
EN 1504-1, Products and systems for the protection and repair of concrete structures- Definitions,
requirements, quality control and evaluation of conformity - Part 1. Definitions
prEN 1504-2, Products and systems for the protection and repair of concrete structures－ Definitions,
requirements, quality control and evaluation of conformity -- Part 2: Surface protection systems for concrete
prEN 1504-3,Products and systems for the protection and repair of concrete structures-Definitions,
requirements, quality control and evaluation of conformity - Part 3: Structural and non structural repair
EN 1504-4, Products and systems for the protection and repair of concrete structures- Definitions,
requirements, quaiity control and evaluation of conformity - Part 4. Structural bonding
prEN 1504-5,Products and systems for the protection and repair of concrete structures- Definitions,
requirements, quality control and evaluation of conformity - Part 5: Concrete injection
prEN 1504-6, Products and systems for the protection and repair of concrete structures- Definitions,
requirements, quaiity control and evaluation of conformity - Part 6: Anchoring of reinforcing steel bar
prEN 1504-7,Products and systems for the protection and repair of concrete structures- Definitions,
requirements, quality control and evaluation of conformity - Part 7: Reinforcement corrosion prevention
EN ISO 9001, Quality management systems - Requirements (ISO 9001:2000)
3
Terms and definitions
For the purposes of this document, the terms and definitions given in EN 1504-1 and the following apply.
3.1
batch
quantity of material made in a single operation, or in the case of continuous production for a defined quantity
(in tonnes) which shall be demonstrated by the producer to have a uniform composition and shall not exceed
one day's production.
3.2
identification test
test carried out to verify a declared value of the composition or property of the product or system in terms of
consistency of the production.
NOTE
This is to ensure that the product or system being testad corresponds to the product or system subjected to
the inifial type test, within the permitted tplerances.

因本站资料资源较多，启用了多个文件服务器，如果浏览器下载较慢，请调用迅雷下载，特别是超过了5M以上的文件！请一定调用迅雷，有时候速度就会飞起哦，如果您的浏览器自动加载了PDF预览，文件太大又卡死，请按下载说明里的把PDF插件关闭了就可以直接下载，不会再预览了！