骨料包裹层厚度的研究及其对多孔混凝土性能的影响
赵洪 ,杨永民1. 。
(1.华南理工大学,广东广州510640;2
李方贤’。张君禄。。余其俊’
广东省水利水电科学研究院,广东广州510635)
摘要: 对复掺粉煤灰和硅灰制备多孔混凝土的性能进行了研究,采用蜡封法测定骨料包裹层厚度,结果表明:骨料包裹层厚
度随浆体黏度、骨料粒径的增加而增加,随着成型外力的增加而减少;在相同骨料粒径和成型工艺下,随着骨料包裹层厚度的增
加,多孔混凝土的抗压强度和透水系数也都会增加,其中,击实成型的骨料包裹层厚度在254~485 m之间,28 d抗压强度和透水
系数分别在4.8~1 1.4 MPa和25~69 mlTl/S之间,插实成型的骨料包裹层厚度在390~545 m之间,28 d抗压强度和透水系数分别在
2.1~5.8MPa和44~95mlTIfS之间。
关键词: 粉煤灰;硅灰;多孔混凝土;骨料包裹层厚度;性能
中图分类号: TU528.01 文献标志码: A 文章编号: 1002—3550(2014)02—0029—04
Study on the thickness of cover layer of aggregate and its influence on properties of porous concrete
ZHAOHone 一,YANG Yongrnin1,2,LIFangxian ,ZHANGJtmlu ,yUQ 蛐
(1.SouthChinaUniversityofTechnology,Guangzhou 510640,China;
2.GuangdongResearchInstitute ofWaterResources andHydropower,Guangzhou 510635,China)
Abstract: The prope~ies of porous concrete with fly ash and silicon fume was studied,the thickness of cover layer of aggregate was
measured by seal wax.The result showed that the thickn ess ofcover layer ofaggregate increased with the increase ofsize ofaggregate an d
viscosity of paste,an d decreased with grow of force of molding.Under the sal$1e size of aggregate an d moulding techniques,the compres—
sive s~ength and permeation coefi cient ofporous concrete all increase with a higher thickn ess ofcover layer ofaggregate.The thickn ess of
cover layer ofaggregate which was moulded by compacting method changed from 254 m to 485 m,leading that compressive strength at
the age of28 d ranging from 4.8 MPa to 1 1.4 MPa and the permeation coeficient was between 25 mnfs and 69 mllfs.Moreover,the thickness
of cover layer of aggregate which was moulded by inserting method changed from 390 m to 545 Ixm,leading that compressive
s~ength at the age of28 d was in the ran ge of2.1-5.8 M Va and perm eation coeficient varied from 44 mmfs to 95 mnfs.
Keywords: flyash;siliconflame;porous concrete;thicknessofcoverlayerofaggregate;property
0 引言 有效。
多孔混凝土(Porous Concrete)又称为植生混凝土、生
态混凝土、透水混凝土,由日本从1980年开始研制并进行
工程应用。由于多孔混凝土既具有连续的贯通大孔又有一
定的使用强度,近些年来引起了国内外对其很多方面的具
体工程应用研究,比如在农牧业[1]、水利工程边坡防护[2-3]、
高速道路交通工程 、城市道路系统的建设同等。
在全世界范围内关于多孔混凝土的制备以及性能已
经有了较为广泛的研究,比如浆体性能、水灰比(w/c)、孔
隙率和强度的关系以及骨料的粒径对透水性能和强度的
影,~jt7~10]等。多孔混凝土是依靠浆体包裹骨料再在黏结点
的紧密结合下形成强度,骨料包裹层厚度以及其包裹的状
态是否均匀直接影响到多孔混凝土的透水和力学性能,本
试验从研究浆体包裹骨料表面的厚度出发,为制备透水性
能、力学性能均良好的多孔混凝土提供参考,显得直观而
收稿日期:2013-08—11
1 试验原材料及试验方法
1.1 试验原材料及性能指标
(1)水泥(C):P·O42.5R级水泥,密度3.00g/cm ,比表
面积386Ⅱl2/ ,化学成分见表1,物理性能见表2。
(2)粉煤灰(FA):I级粉煤灰,密度2.31 egcm,,比表面
积595m:/kg,化学成分见表1。
(3)硅灰(sF):埃肯公司硅灰,密度2.2 g/cm,,比表面
积19 500m2/kg,化学成分见表1
因本站资料资源较多,启用了多个文件服务器,如果浏览器下载较慢,请调用迅雷下载,特别是超过了5M以上的文件!请一定调用迅雷,有时候速度就会飞起哦,如果您的浏览器自动加载了PDF预览,文件太大又卡死,请按下载说明里的把PDF插件关闭了就可以直接下载,不会再预览了!